ci

ci [options] files

Check in revisions. ci stores the contents of the specified working files into their corresponding RCS files. Normally, ci deletes the working file after storing it. If no RCS file exists, then the working file is an initial revision. In this case, the RCS file is created and you are prompted to enter a description of the file. If an RCS file exists, ci increments the revision number and prompts you to enter a message that logs the changes made. In RCS Version 5.6, if a working file is checked in without changes, the file reverts to the previous revision. In older RCS versions, you may end up having to check in a new revision that contains no changes.

The mutually exclusive options -u, -l, and -r, are the most common. Use -u to keep a read-only copy of the working file (for example, so that the file can be compiled or searched). Use -l to update a revision and then immediately check it out again with a lock. This allows you to save intermediate changes but continue editing (for example, during a long editing session). Use -r to check in a file with a different release number. ci accepts the standard options -q, -V, and -x.

Options

-d[date]

Check the file in with a timestamp of date or, if no date is specified, with the time of last modification.

-f[R]

Force a check in even if there are no differences.

-I[R]

Interactive mode; prompt user even when standard input is not a terminal (e.g., when ci is part of a command pipeline). -I is new in RCS Version 5.

-k[R]

Assign a revision number, creation date, state, and author from keyword values that were placed in the working file, instead of computing the revision information from the local environment. -k is useful for software distribution: the preset keywords serve as a timestamp shared by all distribution sites.

-l[R]

Do a co -l after checking in. This leaves a locked copy of the next revision.

-mmsg

Use the msg string as the log message for all files checked in. When checking in multiple files, ci normally prompts whether to reuse the log message of the previous file. -m bypasses this prompting.

-M[R]

Set the working file's modification time to that of the retrieved version. Use of -M can confuse make and should be used with care. (New in RCS Version 5.6.)

-nname

Associate a text name with the new revision number.

-Nname

Same as -n, but override a previous name.

-r[R]

Check the file in as revision R.

-sstate

Set the state of the checked-in revision.

-tfile

Replace RCS file description with contents of file. As of Version 5, this works only for initial check in.

-t-string

Replace RCS file description with string. As of Version 5, this works only for initial check in.

-u[R]

Do a co -u after checking in. This leaves a read-only copy.

-wuser

Set the author field to user in the checked-in revision.

Examples

Check in chapter files using the same log message:

ci -m'First round edits' chap*

Check in edits to prog.c, leaving a read-only copy:

ci -u prog.c

Start revision level 2; refer to revision 2.1 as "Prototype":

ci -r2 -nPrototype prog.c